Product information "Miniature Load Cell H07A"

The H07A is a flat construction miniature single point load cell made from aluminum. The load cell is suitable for small platform scales with a platform size up to 200 x 200 mm.
The load cell is ideally suited when only limited installation space is available, such as in the equipment technology. The miniature sensor delivers highly precise and reliable measuring results even in long-term use.
By default, the load cell H07A is tested and optimised for center load sensitivity. This ensures that there will be no measurement error when the load is placed off centre, eg in a corner of a platform. The load cell is potted and meets the requirements of protection class IP65.

akademische-kappe3 Basic knowledge Load cells

icon_small_pdf Help with selecting a load cell

Area of application

Small platform scales, postal scales, counting scales, filling machines (coffee machines, beverage filling equipment) and weight doses, checkweighers, medical scales an other medical equipment (level control of infusion bottles).
When used as a force transducer thread tensions in the textile industry or rail voltages in the paper industry can be measured.


These load cells operate on the principle of the double cantilever beam and thus ensure accurate measurements. The design is insensitive to off-center force application and can be used for pushed and pulled forces. Threaded holes for attaching the sensor or the defined force introduction ease installation.


  • Material: Aluminum
  • Capacity: 2 - 5 kg
  • Construction: The measuring element is potted
  • Protection class: IP65
  • Compensated Corner load errors
  • Max. Platform size: 200 x 200 mm
  • Low profile
  • Compatible with other manufacturers


The load cell is screwed on via the two screw-on surfaces at the top, front and rear and at the bottom with two steel or aluminium plates (max. 200 x 200 mm).
Parallel connection of several platform load cells is only possible with balanced output (nominal characteristic value and output resistance).



Load cell variants

Type Nominal load , Emax Accuracy class
H07A-G3-0002 2 kg G3
H07A-G3-0003 3 kg G3
H07A-G3-0005 5 kg G3


All information in mm | Technical changes reserved


Breaking load (Ed): 200 % of emax
Cable length: 1 m
Input resistance (RLC) at reference temperature: 415 ± 20 Ω
Insulation resistance: >2.000 MΩ
Limit load (EL): 150 % of Emax
Material: Aluminum
Maximum permitted supply voltage (BU): 15 V
Minimum preload (Emin): 0
Nominal load (Emax): 2 kg, 3 kg, 5 kg
Nominal temperature range (BT): - 10 ... + 40 °C
Nominal value (Cn): 2,0 mV/V
Number of division values (nLC): 3000
Output resistance (RO) at reference temperature: 350 ± 3 Ω
Product-group: Load cell
Protection class according to (DIN 40.050 / EN 60529): IP 65
Recommended supply voltage (Uref): 5 - 12 V
Zero adjustment: ± 3 % v. Cn
Accuracy class: G3

Accessory Items

Miniature Load Cell H08A
Capacity: 1 - 5 kg
Material: Aluminium
Planar beam - Load cell P20A
Capacity: 11.3 - 109 kg
Material: Aluminium